Committed to Service - Innovation - Integrity
Call Today:(909)854-2489
San Bernardino, California
Stainless Steel Bar Grating
Stainless SteelClose-MeshAnchoring DetailsInstallation ClearancesWelding StandardsManufacturing TolerancesWelding Standards
Toeplates
Maximum depth of toeplate is (a+d). It should not extend below the bearing bars. The minimum recommended dimension for "a", the projection of toe plate above the grating, is 4".
Attachment to Length of Bearing Bar
Toeplate to be welded with alternating 1/8" fillet welds, 1" long every 12".
Attachment to End of Bearing Bar
Load carrying toeplates to be welded at each bearing bar with a fillet weld the size of the bearing bar thickness (t), 3/4" long. Non-load carrying toeplates to be welded to bearing bars with 1/8" fillet weld (3/16" for heavy-duty), 3/4" long every 5".Banding
Standard Trim Band
End band to be welded with 1/8" fillet welds (3/16" for heavy duty), 3/4" long every 5".
Load Banding (must specify)
Load carrying end band to be welded with fillet weld the size of bearing bar thickness (t) and the length of bearing bar depth (d) at each bearing bar. This spec is for standard grating. Refer to NAAMM MBG 532 for heavy duty specification.
Contact Us
Location and Directions
Our Address:
1905 W. Rialto Ave.
San Bernardino, CA 92410
Phone:
(909) 854-2489
Fax:
(909) 854-2490
Email: sales@goldenstategrating.com
Please fill out the form below to submit an email to us.
* Indicates required fields.