Committed to Service - Innovation - Integrity
Call Today:(909)854-2489
San Bernardino, California
Aluminum Bar Grating
AluminumClose-MeshAnchoring DetailsInstallation ClearancesWelding StandardsManufacturing TolerancesAnchoring Details
Type H-3 Saddle Clip
The saddle clip bridges two bearing bars and is attached with 1/4" self-tapping bolt, 1/4" self threader, 1/4" weld stud or 1/4" bolt and nut when hole is drilled through supporting flange. Available for 15/16", 1-3/16" and 1-3/8" bear-ing bar spacings (15, 19 and 22 space) in carbon and stainless steel. Fasteners should
Type H-1 Anchor Clip
A flat head J-bolt secures a preformed plate to the underside of steel bearing bars and structural supporting flange. No drilling needed. Access to the underside of grating is required for installation. Available in carbon steel. J-bolt is 1/4" x 2-1/2" for grating up to 2-1/4" deep and 1/4" x 3-1/2" for 2-1/2" to 3-1/2" deep grating.
Welds
Recommended for all permanently installed grating panels. Welds should be 3/16" fillet welds, 3/4" long located approximately 6" from each side of panel (4 locations) and one weld in middle of panel at each intermediate support.
Weld Lugs
Weld lugs may be used for installations where grating is subject to removal. Weld lugs are shop fabricated and must be specified at time of grating order. Fasteners are 1/4" minimum and supplied byothers. Location is the same as "Attachment Locations" diagram.
Attachment Locations
Attachments should be placed at intermediate supports in the middle of the panels and at the four bearing bar ends, 6" from each side of panel. Welds should be 3/16" fillet welds, 3/4" long. Heavy-Duty grating may require additional welding to meet application needs.
Other clips and fasteners available upon request.
Contact Us
Location and Directions
Our Address:
1905 W. Rialto Ave.
San Bernardino, CA 92410
Phone:
(909) 854-2489
Fax:
(909) 854-2490
Email: sales@goldenstategrating.com
Please fill out the form below to submit an email to us.
* Indicates required fields.